Toner Cartridge Printing Defects: Causes and Solutions

Hey all☺,

This is one of the best tutorials on printer defects in the internet -
Hope can help you~

 For any question or suggestion leave a comment❤❤

评论

发表评论

the hot blogger

Printer problems and solution

图片
If you are unable to solve a problem using the solutions in this manual, press the  [POWER]  button and then turn the main power switch to the " "position. Wait at least 10 seconds and then turn the main power switch to the " "position. After the main power indicator changes from flashing green to the lit up state, press the  [POWER]  button. Problem Point to check Solution PRINTING DOES NOT TAKE PLACE Is your PC connected correctly to the machine? Make sure that the cable is connected securely to the LAN connector or the USB port of your PC and that of the machine. If you are connected to a network, make sure that the LAN cable is securely connected to the hub as well. SIDE AND BACK Is the machine connected to the same network (LAN, etc.) as your PC? The machine must be connected to the same network as your PC. If you do not know which network the machine is connected to, ask the network administrator. Is the IP address selected correctly? (Win...
Read more blog »

Replace toner cartridge, drum, or printer?

图片
      If your Brother is finally starting to show its age. It's still on the original toner cartridge, with no sign of running out, but there's now a light coat of toner over the entire page -- as if every page had a light gray background.      You didn't  know you should replace the toner cartridge (relatively inexpensive),the drum (about $20 less than a new printer), or the entire printer?      I dunno about your model, but the MFC model I have came with toner cartridge yield about 3000 pages. I already refilled it twice and just order 2-pack of 6000 pages toner kits.     So I guess your may runs low of toner, and you can buy toner kit (you can get them pretty cheap on EBY) and fill it yourself to save some buck.                                It isn't hard as you just remove the plug, use Shop-Vac to vacuum all the older toner out (I a...
Read more blog »

When the printer runs, Does the print head is run out of ink? Why does it some time is long and some time is short?

图片
Hey all ☺ , That's some printer's issue and solution. Replace question:     When the printer runs, Does the print head is run out of ink? Why does it some time is long and some time is short? Solution：    When the printer is switched on, the print head will consume a certain amount of ink, and the length of time will be determined by Timer Circuit on the motherboard. The circuit in the printer after the shutdown, a button battery can calculate how long the machine is not in use, in the next boot, the printer according to the time data of the circuit provides two boot interval, determine the printer cleaning the long time or short time, if long time no to use the machine and the clean time will be more long.   Don't in order to  "economize" to not use the printer. If the printer doesn't work for a long time,It will cause the print head to clog up and the running part is out of order. The printer will really be broken. If there is no print task, you...
Read more blog »